Always chock your wheels prior to lifting a vehicle.
Reset iac using nissan data scan 2 manual#
Refer to the service manual for specific diagnostic, repair and tool information for your particular vehicle. Information is accurate and true to the best of AutoZone’s knowledge, however, there may be omissions, errors or mistakes.īe sure to consult your owner’s manual, a repair guide, an AutoZoner at a store near you, or a licensed, professional mechanic for vehicle-specific repair information. These tools will not work with any other device other than the Z-Net terminals at AutoZone.Īdvice, how-to guides, and car care information featured on and AutoZone Advice & How-To’s are presented as helpful resources for general maintenance and automotive repairs from a general perspective only and should be used at your own risk. Remember to return the scan tool to an AutoZone employee when finished. In this case, the Malfunction Indicator (Check Engine) lamp on the vehicle’s instrument panel will light steady on. The red LED is also used to show that DTC(s) are present. Red X – Indicates a problem with one or more of the vehicle’s systems.Complete a full drive cycle to allow all the monitors to run, then come back and try to retrieve the code again. Monitor status – This means some of the monitors on the vehicle have not yet finished their diagnostic self testing.All monitors on the vehicle are active and are performing their diagnostic testing, and no trouble codes are present. Green CHECK – Indicates all engine systems are “OK” and running normally.These lights are visual aids to make it easier for you to get an idea of engine system conditions. NOTE ON SCAN TOOL GREEN, RED, and YELLOW LEDs